Photocoupler Lineup  PDF(1.4MB) download
BACK - NEXT

★Under development
Photocouplers
OPIC Output <LSOP type, Gate drive type>
(Ta = 25°C)
Model No.
Internal
connection
diagram
Features
Approved by safety
standards*3
Pac-
kage
Absolute maximum ratings
Electro-optical characteristics
Forward
current
IF
(mA)
Isolation
voltage
(AC)
Viso (rms) (kV)
Propagation delay time
UL
VDE*2
tPHL
(us)
TYP.
tPLH
(us)
TYP.
Vcc
(V)
IF
(mA)
RG
(Ω)
CG
(nF)
★ PC4L23xxIP0F*1
• Built-in drive circuit directly connectable to MOS-FET and IGBT
• Peak output current: 1.5 A
• Low dissipation current
 (Icc = TYP. 2.5 mA)
• High resistance to noise
 (CMR: MIN. 35 kV/µs)
△
△
6-pin
LSOP
25
5.0
MAX.
0.3
MAX.
0.3
15 to 30
7 to 16
47
3
★ PC4L25xxIP0F*1
• Built-in drive circuit directly connectable to MOS-FET and IGBT
• Peak output current: 2.5 A
• Low dissipation current
 (Icc = TYP. 2.5 mA)
• High resistance to noise
 (CMR: MIN. 35 kV/µs)
△
△
6-pin
LSOP
25
5.0
MAX.
0.4
MAX.
0.4
15 to 30
7 to 16
10
10
*1 Wide lead forming type is also available for surface mounting.
*2 A VDE approved type is optionally available.
*3 Please refer to Specification Sheets for model numbers approved by safety standards.

※Notice
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc.
Except where specially indicated, models listed on this page comply with the EU RoHS Directive*. For details, please contact SHARP.
*EU RoHS Directive: EU legislation restricting the use of lead, cadmium, hexavalent chromium, mercury, specific brominated flame retardants (PBB and PBDE), and phthalates (DEHP, BBP, DBP, DIBP).
Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.