SHARP

Language

REPLACING THE TONER COLLECTION CONTAINER

The toner collection container collects excess toner that is produced during printing. When the toner collection container becomes full, the message "Replace toner collection container." will appear.
Replace the toner collection container as instructed by the message in the touch panel.
When the key is tapped, instructions for replacing the toner collection container will appear. Follow the instructions. When the toner collection container is replaced, the message will automatically disappear.

Warning

  • Do not throw the toner collection container into a fire. Toner may fly and cause burns.
  • Store the toner collection container out of the reach of small children.

Caution

Do not touch the internal cords or connectors.

Open the front cover.

Open while pressing the convex parts on both sides.
When a finisher (large stacker) or saddle stitch finisher (large stacker) is installed on the BP-50C55/BP-50C65/BP-70C55/BP-70C65, open the front cover on the finisher (large stacker), or the front upper cover on the saddle stitch finisher (large stacker), before opening the front cover of the machine.

Remove the toner collection container.

Press the release buttons on the sides of the toner collection container, push the toner collection container down until the toner collection container stops, and then slowly lift it up to remove it.

Caution

Keep the replacement cleaner that has not been used. Store it at the left of the new toner collection container.

Place the toner collection container on a flat surface.

Place a sheet of paper such as newspaper on the surface before placing the toner collection container.
  • Keep the toner collection container in an upright position without collapsing it.
  • Do not point the holes down as used toner will spill out.
  • Do not throw away the removed toner collection container, instead place it in the plastic bag provided and keep it in the box in which it was packed.

Install a new toner collection container.

Insert the box from above at a slant. (In the direction opposite to the direction you removed it in.)

Close the front cover.

Hold both sides and close.
Language

Version 04a / bp70c65_usr_04a_us

↑Top of page