FINISHER (LARGE STACKER)

This device outputs sorted paper while staggering each set of paper. As needed, it staples each set. You can also perform stapling manually. To punch holes in printed paper, install an optional hole punch module.

PART NAMES

Output tray (upper tray): The tray is slidable. To print on large paper such as A3 (11" x 17") paper, extend the tray.
Output tray (lower tray): Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as A3 (11" x 17") paper, extend the tray.
Manual staple key: Press to execute manual stapling.
Top cover: Open this cover to remove a paper misfeed.
Insertion slot: Place the paper that you want to staple in this slot. Maximum thickness 9 mm.
Front cover: Open this cover to replace the staple cartridge, remove a staple jam or remove a paper misfeed.

To install a finisher (large stacker), a paper pass unit or folding unit and stand/550/2x550/3x550/550&2100 sheet paper drawer are required.
A finisher (large stacker) cannot be installed simultaneously with an inner finisher, finisher, saddle stitch finisher or saddle stitch finisher (large stacker).
Do not place heavy objects on the finisher (large stacker) or press down on the finisher (large stacker).
Exercise caution when you turn on the power and when printing take place, as the tray may move up and down.

HOW TO STAPLE MANUALLY

You can perform stapling manually.
Make sure the manual staple key is lit green.

Place the paper that you want to staple in the insertion slot.

When you place the paper, the manual staple key blinks green.
After two seconds elapse, stapling automatically starts.

To staple earlier than the auto staple start time, press the manual staple key.

Manual stapling cannot be executed during execution of a staple job.
Manual stapling cannot be executed during auto power shut-off mode.

Relation between paper orientation and stapling result

Paper	Paper orientation when inserted	After stapling

SUPPLIES

The finisher (large stacker) requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SC11

FINISHER (LARGE STACKER) MAINTENANCE

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.