The punch module can be installed on an inner finisher,
finisher or saddle stitch finisher to punch holes in paper to be output.
Punch waste from punched
holes is collected in the punch waste box.
Follow the operation procedure to replace punch waste.
Open the finisher front cover.
While pressing the lever over to the left, slide the finisher to the left until it stops.
Grasp the punch waste box handle, gently pull out the box, and discard the punch waste.
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible to use the punch function.
Slide the finisher to the right until it stops.
Close the finisher front cover.
Open the front cover.
-cover_open.png)
Pull out the punch waste box and discard the punch waste.
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible to use the punch function.
Close the front cover.
-cover_close.png)
Open the front cover.
-cover_open.png)
Pull out the punch waste box and discard the punch waste.
.png)
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible to use the punch function..png)
Close the front cover.
-cover_close.png)
Open the front cover.
Pull out the punch waste box and discard the punch waste.
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible to use the punch function.
Close the front cover.
Open the front cover.
Pull out the punch waste box and discard the punch waste.
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible to use the punch function.Close the front cover.
Version 03a / bp70m65_usr_03a_en
