PUNCH MODULE (MX-PN16B/C/D)

The punch module can be installed on a finisher or saddle stitch finisher to punch holes in paper to be output.

A finisher or saddle stitch finisher is required to install the punch module.

DISCARDING PUNCH WASTE

Punch waste from punched holes is collected in the punch waste box. Follow the operation procedure to replace punch waste.

Open the front cover.

Pull out the punch waste box and discard the punch waste.

Replace the punch waste box.

If the punch waste box is not replaced properly, printing will not be possible to use the punch function.

Close the front cover.