SHARP

Language

AUTOMATICALLY ADJUST SKEWED SCAN DATA (Original Skew Adjustment)

When the original is skewed, or when images within the original are skewed, this automatically corrects the skewing, and saves the document.

  • The post-adjustment image is not shown in preview images, and is displayed as it was scanned.
  • If adjustment is not required and text and images are on an angle for design reasons, adjustment may still occur automatically.
  • If there is little text or image data in the original, this may not be adjusted regardless of the degree of skewing.
  • If an Internet fax address is added as a destination, this function will be disabled.
  • For card shot, this function cannot be used.
  • If [Document Filing] → [Main Folder] → [Property] → [Create PDF for PC Browsing] in System Settings is enabled, this function cannot be used on the document filing function.
  • Depending on the degree of skew, correction may not be possible.

Place the original.

Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
AUTOMATIC DOCUMENT FEEDER
DOCUMENT GLASS

Tap the mode display to switch to the initial screen of each mode.

CHANGING MODES

Specify the destination.

RETRIEVING A DESTINATION FROM AN ADDRESS BOOK
VIEWING A LIST OF THE SELECTED DESTINATIONS
USING A SEARCH NUMBER TO RETRIEVE A DESTINATION
ENTERING AN ADDRESS MANUALLY
SPECIFYING A NETWORK FOLDER
RETRIEVING A DESTINATION FROM A GLOBAL ADDRESS BOOK
RETRIEVING A DESTINATION FROM A MOBILE ADDRESS BOOK
USING A TRANSMISSION LOG TO RESEND

Tap the [Others] key, and tap the [Original Skew Adjustment] key.

A checkmark appears on the icon.
When you have completed the setting, tap the [Back] key.
To cancel the Original Skew Adjustment setting
Tap the [Original Skew Adjustment] key to remove the checkmark.

Tap the [Start] key to start scanning of the original.

When scanning finishes, place the next original and tap the [Start] key.
Repeat until all pages have been scanned and then tap the [Read-End] key.
A beep will sound to indicate that transmission has ended.
Language

Version 03a / bp70m90_usr_03a_us

↑Top of page