FILE TRANSMISSION
The settings used when the file was stored with document
filing are stored, and thus the file can be transmitted using those
settings. If needed, you can also change the transmission settings
to modify the retrieved file.
After selecting the desired file, follow the steps below.
SELECTING A FILE TO RETRIEVE
- A file saved in black and white or
greyscale cannot be transmitted in colour.
- A stored print job cannot be transmitted.
(However, if the job was filed in the printer driver, it can be
transmitted if "Rip Style" is set to [RGB]. This settings
is accessed by selecting the [Other Settings] button on the [Detailed Settings]
tab.)
- These transmission methods require
installation of the corresponding options.
- If any of the following other modes were
included in the saved file, the file cannot be transmitted.
"Stamp", "Photo Repeat"
- If any of the following other modes were
included in the saved file, the file can be transmitted, but other
functions cannot be executed.
"Margin Shift", "Transparency Inserts", "Stamp", "Centring"
- Depending on the reduction or enlargement
ratio used when storing a file, it may not be possible to send the
stored file using a selected resolution setting. In this event,
try changing the resolution.
However,
when sending a stored file by Internet fax, transmission may not
be possible even if the resolution is changed.
- Files saved in other than Internet Fax
mode cannot be sent to an Internet Fax address.
- When the original job is not a Print Jobs,
Fax Receive Job, or Internet Fax Receive Job and the resend format
is a PDF format, this function automatically corrects the skew and
sends if the original is scanned while skewed. Since this functions is
the same as the scanner function, see "
AUTOMATICALLY ADJUST SKEWED SCAN DATA (ORIGINAL SKEW ADJUSTMENT)".
Tap [Send] on the action panel.
Select settings for sending.
Tap the [Start] key.
