FINISHER (LARGE STACKER)
This device outputs sorted paper while staggering each
set of paper. As needed, it staples each set. To punch holes in printed
paper, install an optional hole punch module.
PART NAMES
- Staple compiler
-
This temporarily stacks paper to
be stapled.
- Output tray
-
Stapled and offset output is delivered
to this tray.
The tray is slidable. Extend the tray for printing on large-size
paper (A3W, A3, B4, 12" × 18", 11" × 17", 8-1/2" × 14" and 8-1/2"
× 13" sizes).
- Middle output tray
-
Output paper that will not be offset
in this tray.
The tray is slidable. Extend the tray for printing on large-size
paper (A3W, A3, B4, 12" × 18", 11" × 17", 8-1/2" × 14" and 8-1/2"
× 13" sizes).
- Front cover
-
Open this cover to replace the staple
cartridge, remove a staple jam or remove a paper misfeed.
- To
install a finisher (large stacker), a paper pass unit is required.
- A finisher
(large stacker) cannot be installed simultaneously with an inner
finisher, finisher, saddle stitch finisher or saddle stitch finisher
(large stacker).
- Do not
place heavy objects on the finisher (large stacker) or press down
on the finisher (large stacker).
- Exercise
caution when you turn on the power and when printing take place,
as the tray may move up and down.
SUPPLIES
The finisher (large stacker) requires the
following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three
cartridges)
MX-SCX2
FINISHER (LARGE STACKER) MAINTENANCE
When the staple cartridge runs out of staples,
a message will appear in the operation panel. Follow the operation procedure
to replace the staple cartridge.
Replacement the staple cartridge
Open the front cover.
Squeeze the green parts of the staple case and pull
the case up and then out.
Remove the empty staple cartridge.
When staples remain, the staple cartridge cannot
be removed.
Insert a new staple cartridge into the staple case.
Push the staple case in until it clicks into place.
Install a staple case.
Push the staple case in until it clicks into place.
Close the front cover.
Make a proof copy in staple sort function to verify
that stapling takes place correctly.
DISCARDING STAPLE WASTE
When a finisher is used for stapling, staple
waste is produced.
The staple waste is collected in the staple waste box.
Follow the steps below to discard staple waste.
Open the front cover.
Grasp the tab of the staple waste box, gently pull out
the box, and discard the staple waste.
Caution
- Do
not put your fingers into the staple waste box. The staples may
prick and injure your fingers.
- Do not
discard the staple waste in a plastic bag. The staples may create
holes in the bag.
Replace the staple waste box.
Make sure that the staple waste box is replaced correctly.
Close the front cover.
BEFORE USING THE MACHINE
OPERATION OF THE MACHINE
COPIER
PRINTER
FACSIMILE
SCANNER/INTERNET FAX
DOCUMENT FILING
MANUAL FINISHING
CONVENIENT USE OF THE MACHINE
SETTING MODE
TROUBLESHOOTING
APPENDIX
.png)
_01.png)
_02.png)
_03.png)
_04.png)
_05.png)
_06.png)
_staplewaste_02.png)
_staplewaste_03.png)
