This device outputs sorted paper while staggering each
set of paper. As needed, it staples each set.
To punch holes in printed paper, install an optional hole
punch module.
.png)
The tray is slidable.
To print on large paper such as A3 (11" x 17") paper, extend the
tray.
Stapled and offset
output is delivered to this tray.
The tray is slidable. To print on large paper such
as A3 (11" x 17") paper, extend the tray.
Open this cover to
remove a paper misfeed.
Open this cover to
replace the staple cartridge, remove a staple jam or remove a paper
misfeed.
The finisher (large stacker) requires the
following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three
cartridges)
MX-SCX1
When the staple cartridge runs out of staples, a message will appear
in the operation panel. Follow the operation procedure to replace
the staple cartridge.
Open the front cover.
-cover_open.png)
Pull out the staple unit.
_staple-case_out.png)
Remove the staple case.
-staple-case_output.png)
Remove the empty staple cartridge from the staple case.
Insert a new staple cartridge into the staple case as shown.
Push the staple cartridge in until it clicks into place.
Push the staple case firmly back in.
Push the staple case in until it clicks into place.-staple-case_intput.png)
Replace the staple unit.
_staple-case_in.png)
Close the front cover.
-cover_close.png)
Version 03a / bp70m65_usr_03a_en
