FINISHER (LARGE STACKER)

Staple compiler

This temporarily stacks paper to be stapled.

Output tray

Stapled and offset output is delivered to this tray.
The tray is slidable. Extend the tray for printing on large-size paper (larger than 8-1/2" × 11" (A4)).

Middle output tray

Output paper that will not be offset in this tray.
The tray is slidable. Extend the tray for printing on large-size paper (larger than 8-1/2" × 11" (A4)).

Front cover

Open this cover to replace the staple cartridge or remove a staple jam.

The finisher (large stacker) requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge × three cartridges) MX-SCX2

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.

Open the front cover.

Squeeze the green parts of the staple case and pull the case up and then out.

Remove the empty staple cartridge.

When staples remain, the staple cartridge cannot be removed.

Insert a new staple cartridge into the staple case.

Push the staple case in until it clicks into place.

Install a staple case.

Push the staple case in until it clicks into place.

Close the front cover.

Make a proof copy in staple sort function to verify that stapling takes place correctly.

When a finisher is used for stapling, staple waste is produced.
The staple waste is collected in the staple waste box.
Follow the steps below to discard staple waste.

Open the front cover.

Grasp the tab of the staple waste box, gently pull out the box, and discard the staple waste.

Caution

• Do not put your fingers into the staple waste box. The staples may prick and injure your fingers.
• Do not discard the staple waste in a plastic bag. The staples may create holes in the bag.

Replace the staple waste box.

Make sure that the staple waste box is replaced correctly.

Close the front cover.