Digital multifunctional system BP-B537WR / BP-B547WD

The following describes the parts that appear when the finisher is open.

‹-+›

Output tray: Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper, extend the tray.
Front cover: Open this cover to remove a paper misfeed, replace staples, or remove a staple jam.
Lever: Use this lever to move the finisher in order to remove a paper misfeed, or remove a staple jam.
Staple case release lever: Use this lever to remove the staple case.
Staple case: This holds the staple cartridge.
Pull the case out to replace the staple cartridge or remove a staple jam.

Exercise caution when you turn on the power and when printing take place, as the output tray may move up and down.

The finisher requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SCX1

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.