SHARP

Language

INNER FINISHER

This device outputs sorted paper while staggering each set of paper. As needed, it staples each set.

PART NAMES

The following describes the parts that appear when the finisher is open.

Output tray

Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper, extend the tray.

Front cover

Open this cover to remove a paper misfeed, replace staples, or remove a staple jam.

Lever

Use this lever to move the finisher in order to remove a paper misfeed, or remove a staple jam.

Staple case release lever

Use this lever to remove the staple case.

Staple case

This holds the staple cartridge.
Pull the case out to replace the staple cartridge or remove a staple jam.

Exercise caution when you turn on the power and when printing take place, as the output tray may move up and down.

SUPPLIES

The finisher requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SCX1

INNER FINISHER MAINTENANCE

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.

Replacement the staple cartridge

Open the finisher front cover.

Push lever and move the finisher.

Lower the staple case release lever and remove the staple case.

Pull the staple case out to the right.

Remove the empty staple cartridge from the staple case.

Insert a new staple cartridge into the staple case as shown.

Push the staple cartridge in until it clicks into place.

Push the staple case.

Push the staple case in until it clicks into place.

Return the finisher to the first position.

Close the finisher front cover.

Make a proof copy in staple function to verify that stapling takes place correctly.
STAPLE SETTINGS
Language

Version 03a / bpb550wd_usr_03a _us

↑Top of page