Digital multifunctional system BP-50M26 / BP-50M31 / BP-50M36 / BP-50M45 / BP-50M55 / BP-50M65 / BP-70M31 / BP-70M36 / BP-70M45 / BP-70M55 / BP-70M65

The following describes the parts that appear when the finisher is open.

‹-+›

Output tray: Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as 11" x 17" (A3) size, extend the tray.
Manual staple key: Press to execute manual stapling.
Punch waste box (when a punch module is installed): This stores punch waste discharged from punching.
Insertion slot: Place the paper that you want to staple in this slot. Maximum thickness 11/64" (4 mm).
Front cover: Open this cover to remove a paper misfeed, replace staples, remove a staple jam, or remove the punch waste box.
Staple case: This holds the staple cartridge.
Pull the case out to replace the staple cartridge or remove a staple jam.
Staple case release lever: Use this lever to remove the staple case.
Lever: Use this lever to move the finisher in order to remove a paper misfeed, or remove a staple jam.

The inner finisher cannot be installed at the same time as the folding unit, finisher, finisher (large stacker), saddle stitch finisher or saddle stitch finisher (large stacker).
Exercise caution when you turn on the power and when printing take place, as the output tray may move up and down.

You can perform stapling manually.
Make sure the manual staple key is lit green.

Place the paper that you want to staple in the insertion slot.

When you place the paper, the manual staple key blinks green.
After two seconds elapse, stapling automatically starts.

To staple earlier than the auto staple start time, press the manual staple key.

‹-+›

Manual stapling cannot be executed during execution of a staple job.
Manual stapling cannot be executed during auto power shutoff mode.

Relation between paper orientation and stapling result

Paper	Paper orientation when inserted	After stapling

The finisher requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SCX1

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.