SADDLE STITCH FINISHER

This includes the offset function that outputs sorted paper while staggering each set of paper, the staple sort function that staples each set of prints, the saddle stitch function that automatically staples the center of the sheets and folds the sheets in half, and the paper folding function that folds paper in half.
To punch holes in printed paper, install an optional hole punch module.

PART NAMES

Output tray (upper tray): The tray is slidable. To print on large paper such as 11" x 17" (A3) paper, extend the tray.
Output tray (lower tray): Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as 11" x 17" (A3) paper, extend the tray.
Top cover: Open this cover to remove a paper misfeed.
Saddle stitch tray: Saddle-stitched output is delivered to this tray.
Front cover: Open this cover to replace the staple cartridge, remove a staple jam, or remove a paper misfeed.

To install a saddle stitch finisher, a paper pass unit or folding unit and stand/550/2x550/3x550/550&2100 sheet paper drawer are required.
Do not place heavy objects on the saddle finisher or press down on the saddle stitch finisher.
Exercise caution when you turn on the power and when printing take place, as the tray may move up and down.
A saddle stitch finisher cannot be installed simultaneously with an inner finisher, finisher, finisher (large stacker) or saddle stitch finisher (large stacker).

SUPPLIES

The saddle stitch finisher requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
AR-SC2

SADDLE STITCH FINISHER MAINTENANCE

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.

Open the front cover.