Common Settings

Settings related to the image send function can be configured. The operation settings below apply to all image send functions.

In the Common Settings of the Image Send Settings on the web page, there are two settings under common settings: Condition Settings and Enable/Disable Settings.

THE SETTING MODE LIST OF THE OPERATION PANEL

The description in this section is based on the Web page.

Condition Settings

Address Book Default Selection

Higher priority is given to the display of address book.
If image send mode is enabled, the Address Book is displayed in place of the initial screen of this mode.

Factory default settings:: Disable

Image Orientation

Sets the default image orientation.

Factory default settings:: Portrait

Press Next Address Key ([+]) or [Add] before Selecting the Next Address

Set whether or not the Next Address ([+]) key or [Add] key must be pressed before an address is added for a multi-address job such as broadcast transmission.

Factory default settings:: Disable

Enable/Disable Settings

Settings to Disable Transmission

These settings are used to disable the following transmission operations.

Disable Selection from Address Book
Disables the selection of destinations from the address book.
Configure the setting for each of the following items:

E-Mail

Network Folder/FTP/Desktop

Select All: Select all items.
Clear Checked: Deselect all items.

Factory default settings:: All Invalid

Disable Direct Entry
Disables the direct entry of destination address and others.
Configure the setting for each of the following items:

E-Mail

Select All: Select all items.
Clear Checked: Deselect all items.

Factory default settings:: All Invalid

Disable Storing to USB Memory

Prohibits saving scan data to a USB Memory.

Factory default settings:: Disable

Disabling of Find My Address

This prohibits Find My Address.

Factory default settings:: Disable