Network Settings (Operation panel)

Confirmation of Network

The current network configuration of the machine is displayed.

Connection Type

Switch between [Wired Only], [Wireless (Infrastructure Mode)] or [Wired+Wireless (Direct Connection)] according to the network connection status.

Factory default settings:

Wired + wireless (Direct Connection)

Wired Settings

Configure the wired connection settings.

IPv4 Settings

When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.

Enable DHCP

Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP address.

Factory default settings:

Enable

IPv4 Address

Enter the IP address of the machine.

Subnet Mask

Enter the IP subnet mask.

Default Gateway

Enter the default gateway address.

IPv6 Settings

When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the machine.

Enable IPv6

Enable this setting.

Enable DHCP

Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP address.

Factory default settings:

Enable

Manual Address

Enter the IP address of the machine.

Prefix Length

Enter the prefix length (0 to 128).

Default Gateway

Enter the default gateway address.

Wireless Settings (Infrastructure Mode)

Set up a wireless infrastructure mode connection.

WPS

Connect the machine to the wireless router using WPS.

Push Button Method

Connect to your wireless router using WPS. After tapping this key, press the WPS button on the wireless router to connect.

PIN Code Method

When you tap this key, a PIN code will be displayed. Enter this PIN code into the configuration page of the wireless router you will be connecting to within 2 minutes.

SSID

Enter the SSID using up to 32 characters.

Security Type

Sets the security type of the wireless connection.

Encryption

Select the encryption method according to the item selected in "Security Type".

Security Key

Select a security key according to the item selected in "Security Type".

Security Type	Security Key
WEP	5 single-byte alphanumeric or 10 hexadecimal digits (64bit) or 13 single-byte alphanumeric or 26 hexadecimal digits (128bit)
WPA/WPA2-mixed Personal WPA/WPA2-mixed Enterprise WPA2 Personal WPA2 Enterprise WPA2/WPA3-mixed Personal WPA3 Personal WPA2/WPA3-mixed Enterprise WPA3 Enterprise	8 to 63 single-byte alphanumeric characters or 64 hexadecimal digits

Wireless Settings (Access Point Mode)

Set up a wireless access point mode connection.

Frequency Band

Sets which frequency band to use.

Security Type

Sets the security type of the wireless connection.

Encryption

Select the encryption method according to the item selected in "Security Type".

Security Key

Select a security key according to the item selected in "Security Type".

Security Type	Security Key
WEP	5 single-byte alphanumeric or 10 hexadecimal digits (64bit) or 13 single-byte alphanumeric or 26 hexadecimal digits (128bit)
WPA/WPA2-mixed Personal WPA2 Personal WPA2/WPA3-mixed Personal WPA3 Personal	8 to 63 single-byte alphanumeric characters or 64 hexadecimal digits

Device IP Address Settings

Sets the IP address of the access point.

Channel Settings

Sets the channel used for the access point.

IP Address Distribution Range Setting

Sets the IP address lease range (beginning of IP address and end of IP address) and lease period to be used by the access point.